Heating can raise air and surface temperatures, but heat alone does not remove water from a closed garage. The relative-humidity number may fall as air warms and rise again when it cools. A useful plan therefore tracks moisture sources, temperature and cold surfaces together.
Separate relative humidity from water removal
The Met Office explains that warmer air can hold more water vapour and that relative humidity describes proximity to saturation at the current temperature. If a heater warms unchanged air, its relative humidity can drop even though the water vapour remains in the garage.
Condensation risk depends on whether a surface reaches the dew point. A briefly heated air pocket does not guarantee that a concrete floor, metal door or cold vehicle body has warmed enough to avoid condensation.
Log a complete heat cycle
Place the reference sensor as described in the hygrometer guide and record:
- Conditions before heating.
- Air temperature and relative humidity while heating.
- Visible condensation at cold surfaces.
- Readings for several hours after switch-off.
- Outdoor conditions, rain and door opening.
If the humidity percentage simply rebounds during cooling, the trial may have changed temperature without addressing the moisture load. If water appears after a cold car enters warm moist air, note the vehicle surface as part of the event.
Do not improvise combustion heating
Fuel-burning equipment can introduce combustion gases and, depending on appliance type, moisture. Garages also contain vehicles, fuel and chemicals. Approved Document J covers combustion appliances and fuel storage systems, while HSE requires gas work that falls within the rules to be done by appropriately registered engineers.
Do not use a barbecue, patio heater or unflued domestic improvisation in a garage. Never run a vehicle engine to warm the space. Carbon monoxide cannot be judged by smell.
Specify electric heating as a building decision
For electric equipment, check the garage supply, protective devices, appliance rating, cable routing and suitability for dust, damp and possible splash. Avoid extension leads under tyres or across doorways. Fixed installation and controlled heating may need a competent electrician and consideration of building regulations.
Keep clearances around stored materials and the car. Do not direct high heat at tyres, trim, batteries, paint or a cover. A thermostat measures its own location; it does not certify every surface temperature.
Combine heat with a moisture route
A planned system may use gentle heat to keep surfaces above dew point while ventilation or dehumidification removes moisture. Write down which mechanism is expected to remove water, and measure whether it does.
Repair leaks and remove wet items first. Keep any required ventilation open. If a dehumidifier is included, confirm its operating range and the effect of heating on runtime. Compare energy use and condensation events across similar weather rather than chasing a warmer garage for its own sake.
Review the full plan with ventilation versus dehumidification and the garage leak checklist. The desired outcome is fewer wet surfaces and a controlled environment, not merely a lower relative-humidity display while a heater is on.
Sources & checks
Checked 2026-11-10. Read the original instructions before acting.