For the car. For the long run.
The guides / Garage humidity

Where to put a hygrometer in a garage

Create a useful temperature and humidity log by comparing sensors, avoiding local bias and recording moisture events.

A hygrometer is most useful as a trend recorder, not a dashboard ornament. Placement beside a cold wall, sunny window, wet floor or dehumidifier outlet can produce a real local reading that is unrepresentative of the air around the car.

Decide the question before the position

Choose one main question:

  • What conditions surround the stored car over time?
  • Does a particular wall or floor area create a different microclimate?
  • How quickly does the garage recover after a wet car arrives?
  • Is a dehumidifier changing the wider space or only the air beside it?
  • When and where does condensation appear?

Use a central reference sensor for the first question and temporary comparison sensors for local questions.

Place a reference sensor consistently

Start near the car's mid-height, with free air around the sensor, away from direct sun, heaters, door gaps, wet masonry, the floor and appliance inlet or outlet. Keep it where it will not be knocked or exposed to spray. Follow the sensor maker's limits and mounting instructions.

There is no universal magic height. Record the exact location and avoid moving it without noting the change. A stable imperfect position can still show trends; an unexplained position change makes before-and-after comparison weak.

Use a second sensor to reveal local bias

For a week, place two sensors side by side. Persistent disagreement may reflect specification, response time or calibration difference. Label them; do not average unexplained readings.

Then move the comparison sensor to one suspected area at a time: near the floor but clear of splash, beside an external wall, inside a storage enclosure according to its maker, or near the garage door. Never place an ordinary sensor inside a vehicle cavity or electrical area where it is not designed to operate.

Comparison What it can reveal
Central vs near floor A local cold or damp zone
Central vs near door Outdoor-air influence and opening events
Central vs enclosure Whether the enclosure has distinct conditions
Central vs dehumidifier outlet Why the appliance display may not match the room

Log temperature with relative humidity

The Met Office explains that relative humidity depends on temperature and that condensation begins when a surface reaches the dew point. A rising relative-humidity reading as a garage cools does not necessarily mean new water entered at that moment.

Record at a regular interval and add event notes: rain, washing, wet-car arrival, door opening, heating, ventilation and dehumidifier operation. Daily minimum and maximum values are better than an occasional glance, while timestamped data makes short spikes easier to explain.

Do not turn a consumer sensor into a laboratory claim

Check the maker's stated accuracy and operating range. If two units disagree enough to change a decision, compare them with a traceable reference or replace the uncertain sensor. “Calibration” buttons on some devices only apply an offset; they do not establish the correct value by themselves.

Keep sensors clean and replace batteries before a monitoring period. Do not mount them above a chemical store, close to exhaust fumes or where condensation can drip onto electronics.

Review patterns, not a single target

Mark repeated condensation events, long damp periods and sharp changes after specific activities. Use those patterns to inspect leaks, alter a routine or size an equipment trial. If the garage is outside a dehumidifier's stated temperature range, a humidity set point alone does not make the setup suitable.

Take the record to is my garage too damp? and compare ventilation with dehumidification. Keep the original data when you make a change so the result can be checked across similar weather.

Sources & checks

Checked 2026-11-10. Read the original instructions before acting.