Wheel arches and the underside collect road film, mud and winter contamination, but access is awkward and the car contains finishes and components that should not be treated as one washable surface. Start with the owner's handbook and a safe-access decision, not with the pressure-washer trigger.
Decide what you can clean from ground level
Walk around the parked, cool vehicle on level ground. With a torch, record what is visible through the wheel openings and from the perimeter. Identify loose liners, hanging shields, fresh leaks, damaged wiring and flaking coatings before water changes the evidence.
Do not get beneath a vehicle supported only by a jack. HSE's guidance for work under vehicles calls for suitable rated equipment, correct lifting points, hard level ground and other controls. Home rinsing from the edge is not an underside inspection. If the job requires wheels, liners or covers to be removed, book suitable workshop access.
Read the model-specific exclusions
Find the handbook sections for exterior cleaning, underbody cleaning and pressure washing. Look for instructions covering:
- Cameras, parking sensors and radar units.
- Brake parts and hot exhaust components.
- Electrical connectors, high-voltage cables and charging equipment.
- Wheel finishes, polished metal and decorative coatings.
- Underbody shields, drain openings and sound-deadening material.
- Minimum nozzle distance, spray pattern, temperature and pressure where stated.
Do not transfer one manufacturer's pressure or distance figure to another vehicle. If the documentation is silent, ask the manufacturer or a specialist rather than choosing a more aggressive setting.
Remove contamination without concealing damage
Begin with low force and plenty of clean water so loose grit can leave the surface. Work methodically around each arch. Avoid directing a concentrated jet into seams, damaged coatings, boots, bearings, connectors or unidentified holes. Do not scrape underseal or poke drains as part of a wash.
Ford's current guidance for some vehicles says to flush the underside frequently, keep body and door drain holes free of packed dirt, and rinse suspension components after coastal, dusty or muddy use. It also notes that a short drive after cleaning can reduce corrosion risk at brake friction parts before extended parking. Those details illustrate the questions to find in your own handbook.
Dry, inspect and record
Allow water to drain in an appropriate place. Follow the handbook on drying the brakes and do not drive if the pre-drive check identifies a concern. GOV.UK reminds drivers that a current MOT does not by itself prove continuing roadworthiness.
Once the accessible surfaces are clean and dry, photograph:
| Area | Change to record |
|---|---|
| Arch lip and liner edge | Blisters, trapped debris, loose fixings |
| Sill and jacking-point area | Disturbed coating, deformation, staining |
| Visible seams | Cracks, gaps, lifting sealer |
| Shields and fasteners | Missing, loose or damaged parts |
| Brake area | Persistent contamination or anything needing professional assessment |
Water emerging from a cavity is an observation, not proof that a drain is working correctly. A recurring patch or wet interior needs the water-entry workflow. A damaged coating should be assessed using the underbody inspection guide before another layer is added.
Set the next trigger
Base the next check on actual use: salty spray, mud, coastal roads, a winter tour or a newly discovered coating defect. Add it to the winter cleaning plan and keep before-and-after photographs. The repeatable record is the useful output; forceful cleaning without inspection can simply move dirt while leaving the important questions unanswered.
Sources & checks
Checked 2026-11-10. Read the original instructions before acting.