A wet carpet, water in a door or a damp boot does not identify the entry point. Water can travel behind trim, along seams and through wiring routes before it becomes visible. Build an evidence trail before clearing, sealing or drilling anything.
Make a water map
Record the first time and place water appears. Include recent rain direction, washing, roof operation, air-conditioning use and where the car was parked. Photograph the wet boundary before lifting loose mats, then check only areas the handbook makes owner-accessible.
Create separate entries for:
- Front or rear footwell, including left or right.
- Door cavity or sill edge.
- Boot floor, spare-wheel well and lamp area.
- Headlining, pillar trim or sunroof aperture.
- Scuttle or plenum area below the windscreen.
- Condensation on glass without a distinct liquid-water trail.
Do not assume all moisture has one cause. A blocked drain, failed seal, body repair, cooling-system leak and ordinary condensation need different responses.
Identify drains from vehicle information
Search the owner's manual, body-care instructions and manufacturer repair information for the exact model and roof type. Some Ford vehicle information, for example, warns that leaves or dirt in plenum drains can allow water into the interior and directs cleaning of the covered area to a qualified workshop. Other Ford guidance asks owners to keep body and door drain holes free of packed dirt.
That does not make every visible hole a drain or make wire, screwdrivers and compressed air suitable tools. Unknown openings may contain valves, coatings or nearby wiring. Ask a marque specialist to identify the route and approved clearing method.
Use controlled observations
Remove loose surface leaves by hand only where access is intended and safe. Check door and boot seals for displaced sections, tears and trapped dirt without pulling bonded trim apart. If a workshop performs a water test, ask it to isolate one area at a time and record where water was applied and where it appeared.
Avoid flooding the car with a pressure washer to “find the leak”. High-pressure water can create a path that normal rain does not use. Do not seal a suspected exit hole to stop water appearing; that can trap more water in a cavity.
Drying is not diagnosis
Remove wet loose items and follow the handbook for interior care. Arrange professional removal where trim, airbags, high-voltage components or wiring are involved. A dehumidifier may help dry the garage air, but it does not repair the entry route or prove a cavity is dry.
Track temperature and relative humidity alongside the water map. If the glass is wet while carpets and cavities remain dry, work through the interior condensation guide. If a floor or trim stays wet after rain, prioritise the leak investigation.
Decide when the car needs a workshop
Seek competent help when water is near electrical systems, restraint components or the high-voltage system; when mould or odour returns; when a bonded screen or roof system is implicated; or when access requires lifting the car or removing fixed trim. HSE's under-vehicle guidance is a useful reminder that safe access needs more than a jack.
Ask the workshop to record the confirmed entry point, route, repair, drainage check and drying method. Keep the report with dated photographs. At the next spell of comparable rain, inspect the same locations before declaring the issue resolved.
Water management is part of corrosion prevention, but it is not a licence to alter the body. Link the final record to the rust inspection checklist and any known cavity treatment so future work does not mistake a repair hole, drain or access plug for something else.
Sources & checks
Checked 2026-11-10. Read the original instructions before acting.