For the car. For the long run.
The guides / Laying up

Storing a car on axle stands: questions before lifting

Decide whether long-term support is manufacturer-approved and plan load points, surface, suspension position and safe access with a competent workshop.

Lifting a car for storage is sometimes suggested to prevent tyre flat spots, but long-term support can load the body or suspension in ways the vehicle maker did not intend. It also creates a severe crush hazard. Do not put a car on stands without vehicle-specific approval and suitable equipment.

Ask whether lifting is needed at all

Start with the tyre and vehicle storage instructions. They may specify pressure changes, tyre supports or periodic movement instead. DeLorean Motor Company, for example, cautions that lifting can place some suspension bushings under undesirable tension for its cars. That is model-specific but demonstrates the trade-off.

Write down the problem you intend to solve, storage duration and alternatives considered. Convenience for underside access is not a reason to leave a car raised unattended.

Obtain exact support information

The owner's manual's emergency jack points may not be approved for long-term support. Ask the manufacturer or a marque specialist for:

  • Permitted support points and load-spreading method.
  • Whether suspension should remain loaded or hang free.
  • Air, hydraulic or self-levelling suspension service mode.
  • Body, chassis and corrosion condition requirements.
  • Wheel-chock and transmission instructions during lifting.
  • Whether doors, roof or tailgate may be operated while supported.

DVSA tells MOT testers to use manufacturer information and take particular care with pneumatic, hydraulic and self-levelling suspension. A home storage setup needs the same respect for model-specific systems.

Treat the floor and equipment as one system

HSE says work beneath vehicles requires suitable rated equipment, correct lifting points, hard level ground and secure controls; a jack alone is not support. Stand rating, base size and height must suit the vehicle and floor. Concrete condition and local point loading may need professional assessment.

Do not use bricks, timber offcuts or improvised packing. Do not work alone under a newly supported vehicle to “check stability”. Have a competent workshop perform the setup if long-term lifting is approved.

Plan the stored state

Record stand locations with photographs, contact protection, suspension position, wheel storage and vehicle restraint. Keep people, children and pets out of the area. Protect the setup from vehicle impact and do not use the car as a shelf.

Set an inspection interval for floor cracking, stand movement, corrosion at contact points and fluid leaks. Observation must be possible without entering the crush zone.

Plan lowering before raising

Write the lowering sequence, required tyre pressures, wheel torque procedure and recommissioning checks in advance. Stands or lifting equipment may corrode or seize during a long lay-up. Do not improvise removal if the car has shifted.

After lowering, inspect support points, tyres, suspension, brakes and fluids before movement. Complete recommissioning after storage and seek professional help for any deformation, instability or unusual ride height.

Sources & checks

Checked 2026-11-10. Read the original instructions before acting.