Long-term storage does not make fluid specifications interchangeable or remove service intervals. Build a record from the owner's handbook and service history, then resolve leaks and unknown mixtures before the car is parked out of sight.
Make one row per system
Record the exact specification, last service date and observed level or condition for:
- Engine oil and filter.
- Engine coolant and antifreeze protection.
- Brake and clutch fluid where applicable.
- Transmission, differential and power-steering fluids where owner checks are permitted.
- Windscreen and headlamp washer fluid.
- Hydraulic roof or suspension systems where fitted.
Do not open reservoirs or remove caps unless the handbook describes an owner check and the system is at the required temperature and condition. High-temperature, pressurised and high-voltage systems need particular care.
Treat a low level as a question
GOV.UK and the Highway Code tell drivers to use the handbook for fluid checks and servicing. A level below its normal range can indicate a leak or maintenance issue; topping up without investigating may hide the evidence.
Photograph the floor patch and container level, note colour and location, and keep people and pets away. Do not identify automotive fluids by taste or close smelling. Brake fluid, fuel, coolant and waste oil require different handling.
Confirm timing with the vehicle maker
Ask whether any service is due by time during the planned storage period. Some storage instructions call for an oil change or specific coolant check before lay-up; others depend on normal schedules. Record the instruction and do not transfer it across models.
For coolant, confirm the approved product, concentration method and compatibility with what is already present. Colour alone does not establish chemistry. A workshop can test freeze protection and system condition using the appropriate procedure.
For brake fluid, use the service interval and specification. Moisture content or boiling-point assessment is not a reason for a home experiment; braking systems are safety-critical.
Store chemicals separately and safely
Do not keep opened fluids on the car, floor or near ignition sources. Retain them in labelled original containers according to instructions. HSE's motor-repair COSHH guidance identifies fuels, brake fluids, lubricants and waste oil among substances requiring control.
Arrange lawful disposal for old fluid and contaminated absorbent. Never pour automotive fluid into a drain or onto the ground.
Create the recommissioning row
Before first start, repeat permitted level checks and inspect the floor. Record any new patch, crystallised coolant trace, hose staining or change in reservoir level. If the car was serviced before storage, that does not eliminate the need to look for a leak.
After safe initial running, follow the handbook for warning lights and rechecks. Stop for abnormal pressure, temperature, pedal feel or leakage. A workshop should investigate anything safety-related before road use.
Add the fluid sheet to recommissioning after storage and starting a stored car. Keep legal checks, battery care and fluid condition as separate rows so one completed task does not make the whole car “ready”.
Sources & checks
Checked 2026-11-10. Read the original instructions before acting.